Home
<p><strong>Common problems and solutions of fiber<a href="https://www.tumtecchina.com/" target="_blank"> fusion</a> <a href="https://www.tumtecchina.com/" target="_blank">splicer</a></strong></p><p>1. After turning on the switch of the optical fiber <a href="https://www.tumtecchina.com/" rel="noopener noreferrer" target="_blank">fusion</a> splicer, the screen is not bright, and after opening the draft shield, it is found that the horizontal lighting on the electrode holder is not bright.</p><p> Solution:</p><p>1〉 Check if the power plug socket is properly inserted, if not, re-plug it.</p><p>2> Check whether the power fuse is disconnected. If it is broken, replace the spare fuse.</p><p><br></p><p> 2. The optical<a href="https://www.tumtecchina.com/" rel="noopener noreferrer" target="_blank"> fiber</a> can be reset normally, the screen becomes dark during the gap setting, there is no fiber image, and the screen display stops at "set gap".</p><p> Solution:</p><p>Check and confirm whether the draft shield is pressed in place or the reed is in good contact.</p><p><br></p><p> 3. After turning on the optical fiber <a href="https://www.tumtecchina.com/" rel="noopener noreferrer" target="_blank">splicer</a>, "Battery is exhausted" appears on the bottom of the screen and the buzzer beeps continuously.</p><p>Solution:</p><p>1> This phenomenon generally occurs when the battery is used for power supply, just replace the power supply.</p><p>2> Check if the power fuse box is tightened.</p><p><br></p><p> 4. The fiber can be reset normally. When the gap is set, the fiber appears on the screen but stops, and the screen display stops at "set gap".</p><p> Solution:</p><p>1> Press the "Reset" key to reset the system.</p><p>2> Open the draft shield and open the left and right pressure plates respectively. The following checks are performed in sequence:</p><p>3> Check if there is any fiber break.</p><p>4〉 Check if the fiber cut length is too short.</p><p>5〉 Check whether the fiber loading slot matches the optical fiber. And deal with it accordingly.</p><p><br></p><p> 5. The optical fiber can be reset normally. When the gap is set, the optical fiber continues to move backward, and the screen displays "set gap" and "reinstall the fiber."</p><p>Solution:</p><p>May be caused by excessive dust deposition on the eyepiece of the microscope in the optical system. Wipe the eyepieces of the horizontal and vertical microscopes with a cotton swab stick. Observe no obvious dust with your eyes and try again.</p><p><br></p>
products
