Home
<p>Matters needing attention when installing <a href="https://www.lepuseal.com/products-1" rel="noopener noreferrer" target="_blank"><a href="https://www.lepuseal.com/products-1" target="_blank">mechanical seal</a></a>:</p><p>1. Be very careful and avoid installation deviations in the installation</p><p>1) The tightening of the gland should be held after the coupling is aligned. The bolts should be symmetrically supported to prevent the end face of the gland from deviating. Check each point with a feeler gauge, and the deviation should not exceed 0.05mm.</p><p>2) Check the joint clearance (ie concentricity) between the gland and the outer diameter of the shaft or sleeve. The circumference should be symmetrical. Use a feeler gauge to check that the tolerance at each point is not more than 0.01mm.</p><p>B. The compression of the spring should be carried out according to the regulations, and it is not allowed to be too large or too small, and the deviation is required to be 2.00mm. Too much increase the end-face specific pressure and accelerate end-face wear. If it is too small, the specific pressure will not be as good as the sealing benefits.</p><p>C. After the moving ring is installed, it should be able to spring back automatically after pressing the moving ring to the spring.</p><p><br></p><p>Position requirements for mechanical seal installation: In order to ensure the stable operation, long life and low leakage performance of the mechanical seal, it is very important to accurately install it on the machine.</p>
products
