Home
<p>Maintain a stable and proper air pressure</p><p>1. The size of the air pressure depends on the material of the nailed object and the size of the nail. The ideal air pressure should be set from a low pressure and gradually increase the pressure until a satisfactory nailing effect is achieved. Before using the tool, check the air pressure, * Do not exceed the specified air pressure, otherwise it may cause the tool to burst. The air pressure required by the AirNailers must be maintained when fast nailing, otherwise the power cannot be fired continuously.</p><p>2. The air source must be dry and dust-free ordinary compressed air, oxygen and any flammable gas are strictly prohibited to avoid accidental injury.</p><p>3. When the <a href="https://www.gdfshuajian.com/air-stapler" rel="noopener noreferrer" target="_blank">air staple gun</a> and the air pipe are connected, unless the nailing work is carried out, the trigger must not be buckled to avoid accidental launch.</p><p>4. After each work, the air pressure tube must be separated from the tool.</p><p>5. When multiple air staple guns share a compressor, the capacity of the compressor must match it, otherwise the air pressure will be insufficient.</p><p><br></p><p>Use lubricating oil correctly</p><p>In order to maintain the best working performance of the tool, a small amount of lubricating oil must be used frequently. Before using the tool, please add a few drops of lubricating oil. Use good lubricating oil, which is very critical to the service life of pneumatic tools. Use clean oil or oil with any additives. Improper use of lubricant will damage the internal parts of the tool.</p><p><br></p><p>Use air filters and oil-water separators appropriately</p><p>The moisture and dust in the air are the main reasons for the wear of the air staple gun. Therefore, a filter must be installed to reduce wear. The filter must be clean and effective in purifying the air. The filter needs to be cleaned frequently. If there is dust on the filter Or it is blocked, then the air pressure will be reduced, thereby affecting the nailing performance.</p><p><br></p><p>Instructions for use in severe cold</p><p>In severe cold and below freezing, measures must be taken to prevent the air compression tube from freezing. It is recommended to use good winter lubricating oil and antifreeze to effectively protect the tools.</p><p><br></p>
products
