Home
<p>1. Moisture-proof</p><p>The most worried thing about electrical appliances is humidity, which will reduce the service life and be dangerous to electricity. Therefore, the key step in the maintenance of <a href="https://www.timingcherish.com/floor-standing-lamps" rel="noopener noreferrer" target="_blank">floor standing lamps</a> are moisture-proof, whether it is placed in the living room, or the lighting in the bathroom, bathroom and the stove lamp in the kitchen. , It is necessary to install moisture-proof lampshade to prevent moisture intrusion and promote rust damage or leakage short circuit of the lamps.</p><p><br></p><p>2. Dust removal</p><p>Floor lamp maintenance requires frequent dust treatment, especially the lampshade of floor lamp. The lampshade is easy to accumulate ash layer and cause darkening and affect the lighting effect, so it should be cleaned frequently. When cleaning the lampshade of the floor lamp, use a clean feather duster to gently sweep away the dust, so as not to deform the lampshade.</p><p><br></p><p>There are several situations for floor standing lamp dust removal and wiping:</p><p>(1) For normal cleaning, use a clean feather duster to gently dust off. Be very careful.</p><p>(2) If it is a non-metal floor lamp, you can wipe it clean with a damp cloth, being careful not to wipe the power cord.</p><p>(3) If it is a metal lamp, wipe it with a dry cloth, never get wet.</p><p><br></p><p>Note: When cleaning and maintenance, disconnect the power supply first. At the same time, be careful not to change the structure of the lighting, and do not change the parts of the lighting casually. After the cleaning and maintenance, you should install the lighting as it is, and do not miss or install it incorrectly. Lighting parts to avoid danger. At the same time, do not clean the lamp with water as much as possible, just wipe it with a dry cloth dampened with water. If you accidentally touch the water, try to wipe it dry as much as possible. Do not wipe it with a wet cloth immediately after turning on the light.</p><p><br></p><p>3. Don't switch frequently</p><p>When using lighting, try not to switch frequently, because when lighting is frequently started, the current through the filament is greater than the current during normal operation, which makes the temperature of the filament rise sharply and accelerates sublimation, which will greatly reduce its service life. One point to pay attention to in all lighting maintenance.</p>
products
