Home
<p>The sliding <a href="https://www.appollobath.com/" rel="noopener noreferrer" target="_blank"><strong><a href="https://www.appollobath.com/" target="_blank">shower room</a></strong></a> pulley can be regarded as the top priority in the sliding shower room. The pulley with reasonable structure and good material can guarantee the service life of the shower room and the safety of consumers. So how to distinguish the quality of the shower glass door pulley? If the pulley is broken, how to repair it?</p><p><br></p><p><br></p><p>How to distinguish the quality of the shower room pulley:</p><p><br></p><p><br></p><p>1. Look at the material of the pulley and the sealing of the wheel seat</p><p><br></p><p>The wheel seat of the pulley should be made of compression-resistant and heavy-duty materials, such as 304 stainless steel and high-end synthetic materials. The seal of the wheel seat is good, water vapor is not easy to enter the wheel, and the smoothness of the wheel is guaranteed.</p><p><br></p><p><br></p><p>2. Look at the compatibility of the pulley and aluminum track</p><p><br></p><p>The pulley and the track should be closely matched, with a small gap, and not easy to fall off when impacted by external forces to avoid safety accidents.</p><p><br></p><p><br></p><p>How to repair the shower room pulley:</p><p><br></p><p>1. If your sliding door is stuck, lubricate the roller with penetrating oil. Remove any debris from the track, which may hinder the movement of the door.</p><p><br></p><p><br></p><p>2. If the glass door swings or the stick adjusts the roller, because it moves along the track, the door moves. Look at the small holes at the top of the door and the rollers near the bottom. Depending on the design of your door, the adjustment holes can be in the front of the door or along the edge. Insert a small Phillips screwdriver into each hole and turn the expansion roller counterclockwise if your door is too loose. If the door card retracts the roller, turn the screwdriver clockwise.</p><p><br></p><p>3. Lift the bottom of the sliding door vertically upward from the rollers of the track to remove the bottom set. Pull the door down away from the top rail to loosen the top roller. Place the door on a sturdy table or workbench roller, so you have a clear statement.</p><p><br></p><p>4. Check the roller and replace any damaged, damaged or worn. To remove the roller, the screw above the adjustment hole. Try not to separate the door frame, glass pull-off roller.</p><p><br></p><p>5. Remove the mounting screws along the top and bottom doorways, if the track is damaged or shows signs of wear. Install the replacement track, and tighten the screws to fix it on the new track.</p>
products
