Use of mechanical seal equipment

<p>Use of <a href="https://www.lepuseal.com/products-1" target="_blank">mechanical seal</a> equipment</p><p><br></p><p>&nbsp;&nbsp;&nbsp;&nbsp;Mechanical seal equipment is a kind of oil seal equipment for rotating machinery. It has high requirements for the quality of equipment that cooperates with separate <a href="https://www.lepuseal.com/products-1" rel="noopener noreferrer" target="_blank">mechanical seals</a> for other phase pumps. Under the pressure and compensation arrangement elastic force (or magnetic force) and the cooperation of the auxiliary seal, the Grundfos mechanical seal is adhered to and relatively sliding to form a pump-proof cartridge mechanical seal to prevent fluid leakage. At the same time, what should be paid attention to in use?</p><p>&nbsp;&nbsp;1. The radial runout of the imported mechanical seal of the equipment shaft should be ≤0.04mm, and the axial movement of the printing and dyeing mechanical seal is not allowed to be greater than 0.1mm;</p><p>&nbsp;&nbsp;2. The sealing part of the equipment should be kept clean during the equipment, the sealing parts should be cleaned, and the sealing end face should be intact to prevent impurities and dust from being brought into the sealing part of the cartridge mechanical seal;</p><p>&nbsp;&nbsp;3. It is forbidden to hit or hit during the equipment process to prevent the mechanical seal from being damaged due to the damage of the mechanical seal;</p><p>&nbsp;&nbsp;4. When the equipment is in contact with the seal, a layer of clean mechanical oil should be applied to the surface, so that the equipment can be smooth;</p><p>&nbsp;&nbsp;5. When the static ring gland of the equipment is tightened, it is necessary to tighten the screws evenly to ensure that the end face of the static ring is perpendicular to the axis line;</p><p>&nbsp;&nbsp;6. Push the moving ring by hand after the equipment, which can make the moving ring move flexibly on the shaft, and has a certain degree of flexibility;</p><p>&nbsp;&nbsp;7. Turn the shaft by hand after the equipment, and the shaft should have no light or heavy feeling;</p><p>&nbsp;&nbsp;8. The equipment must be filled with media before operation to prevent dry interference and seal failure.</p>