How to deal with the failure of the chainsaw cutting machine

<p><a href="https://www.ntjl.com/chain-saw-series" rel="noopener noreferrer" target="_blank">Chainsaw cutting machine</a>&nbsp;is a garden tool that uses a gasoline engine to drive a mechanical saw to cut tree branches. It is easy to carry, hand-held use, when the fuel tank is filled with gasoline, it can start to work. The following are some of the possible faults and solutions for chainsaw cutting machines.</p><p><br></p><p>1.&nbsp;If the chainsaw cutting machine&nbsp;shows signs of refueling and stalling, the task is not so energetic, the heating machine is overheated, etc., it is generally a filter problem. Therefore, before the task, it is necessary to stop introspection on the filter, and the clean and qualified filter should be inspected at the sun, it should be thorough and bright, otherwise it is unqualified. When the filter of the chainsaw cutting machine&nbsp;is not clean enough, it should be washed with hot soapy water and dried. Only a clean filter can ensure the normal use of the chainsaw cutting machine.</p><p><br></p><p>2.&nbsp;When the serrations of the chainsaw cutting machine&nbsp;become not sharp, you can use a special file to stop the cutting teeth of the serrated chain to ensure the sharpness of the serrations. At this time, it should be noted that when using a file to frustrate, you must frustrate in the direction of the cutting tooth, not the other way around. At the same time, the angle between the file and the chain of the chainsaw cutting machine&nbsp;should not be too large, preferably 30 degrees.</p><p><br></p><p>3.&nbsp;Before using the chainsaw cutting machine, the chain oil should be added. The benefit of this is that it can provide smoothness to the chainsaw cutting machine, increase the frictional heat between the chainsaw cutting machine&nbsp;chain and the chainsaw cutting machine&nbsp;guide plate, and protect the guide plate. It can protect the chainsaw cutting machine&nbsp;to avoid premature scrapping.</p><p><br></p><p>4.&nbsp;After the chainsaw cutting machine&nbsp;is used, the chainsaw cutting machine&nbsp;should also be stopped for maintenance, so that the task efficiency can be guaranteed when the chainsaw cutting machine&nbsp;is used next time. The first is to remove the impurities in the oil inlet hole and the guide plate groove at the root of the chainsaw cutting machine&nbsp;to ensure the smoothness of the oil inlet hole. Secondly, clear the debris in the guide plate head and add a few drops of engine oil.</p>