Home
<p>The <a href="https://www.ntjl.com/strapping-machine" rel="noopener noreferrer" target="_blank">strapping machine</a> is mainly a kind of packaging equipment that uses a baling belt to bundle the packaging. It is mainly bonded and cut by the blade of the baler. The products packaged by the strapping machine are good for transportation, storage, and have a more beautiful appearance. But the packer will definitely have different problems after being used for a long time.</p><p class="ql-align-justify"><br></p><p class="ql-align-justify">1. What should I do when the packing tape cassette appears on the strapping machine?</p><p class="ql-align-justify">When the strap is stuck in the middle of the rollers, or there is a foreign body that cannot be removed, remove the washer of the hexagonal nut and loosen the two M5 countersunk screws on the middle connecting shaft, because these two screws are fixed on the connecting shaft The notch part of the core, so the screw must be turned on; remove the connecting shaft, pick up the upper turbine, and remove the jam. Finally, it can be assembled and restored according to the above method. Pay attention to the gap between the nut and the L-shaped curved plate of 0.3-0.5mm.</p><p class="ql-align-justify"> </p><p class="ql-align-justify"> 2. After the strapping machine is finished, the cutter does not cut the tape. What is the reason?</p><p class="ql-align-justify">1. The tightness adjustment is too tight;</p><p class="ql-align-justify">2. The slip sheet or slip belt has oil and must be removed to wipe off the oil;</p><p class="ql-align-justify">3. The belt is too tight, so adjust the belt drive seat down, or adjust the motor backward;</p><p class="ql-align-justify"> </p><p class="ql-align-justify">3. What to do when the bonding degree of the packing tape is not enough?</p><p class="ql-align-justify">1. The temperature is too high or not enough, sometimes special belts have poor viscosity, and the temperature must be very accurate;</p><p class="ql-align-justify">2. The voltage used is not enough. There are many factories with insufficient voltage. If you use extension cords or cables, it will cause a voltage drop, which will make the originally adjusted temperature lower, or even burn out when the motor is tightened, so try to avoid using cables If you must use an extension cord, you must connect a thicker but not too long wire;</p><p class="ql-align-justify">3. The electric heating steel sheet is too high or too low, or to the left or right, so it touches the upper and lower brbr belts, or the left and right tools, and cannot enter the heating. It must be adjusted according to the situation;</p><p class="ql-align-justify">4. The micro-fan for exhausting smoke fails, which makes the temperature too high.</p><p class="ql-align-justify"> </p><p class="ql-align-justify">4. What should I do if the automatic strapping machine does not produce the packing belt?</p><p class="ql-align-justify">First check whether the "adjustment of the tape length" is at "0", and then check whether the threading process is correct; if not, check whether there is a foreign object stuck near the belt feed roller, which may also cause this situation.</p><p><br></p>
products
