How to quickly and correctly replace the packing belt

<p>When customers change the packing belt, there are often some unexpected problems, sometimes it takes a long time, so on how to quickly and correctly replace the packing belt, we will briefly share how the <a href="https://www.ntjl.com/strapping-machine" rel="noopener noreferrer" target="_blank">strapping machine</a>&nbsp;can be replaced quickly and correctly packing belt.</p><p>&nbsp;</p><p>Change the packing belt to do it without panic, calm and stable.</p><p>&nbsp;</p><p>When the strap is still enough for 2-3 packs, remove the strap from the strap rack and put it next to it, which will help to have a certain time to replace the new strap without affecting normal production.</p><p>&nbsp;</p><p>After changing, wear the straps in order, and finish typing the remaining previous rolls, usually the last one. Routine economy and eliminate waste. Put on the newly-changed packing belt again to complete the belt changing process. When the new belt is replaced, there will be uneven elasticity, and the elastic button should be adjusted in time until it meets the process standard. Adjust the packing belt to a moderate degree, too tight and easy to tie the belt, too loose and does not meet the process requirements. It must be adjusted to meet the technical standards, so as to ensure the success rate of belting.</p><p>&nbsp;</p><p>At the same time, we also need to carry out effective maintenance and correct use of the baler.</p><p>&nbsp;</p><p>Before starting the machine, you must check whether the photoelectric tube of the packing machine is in good condition, whether the reflector is aligned and whether there is dust on it. If it is not aligned, put it in the correct position and remove the dust on it. Whether the screws and nuts of all parts are loose, they should be tightened in time.</p><p><br></p><p>If there are missing nails and caps, the repairer must be notified to deal with it in time. Check whether there is any blockage in the belt conveyor. If it must be removed, use compressed air to blow out the dust in the belt conveyor. Check whether the crankshaft is short of oil. If it is missing, the crankshaft must be refueled by a dip method, usually a small stick is used to dip the oil, and slowly drip onto the shaft, and cannot flow into the belt conveyor in an inverted manner. Slip when strapping, won't take up, won't tie the strap tightly.</p><p>&nbsp;</p><p>If abnormal phenomena are found during the start-up process, such as loud sound, loud vibration, peculiar smell, etc., if you can't find it by yourself, you should stop the machine and call the repairer to deal with it to avoid damage to internal parts.</p><p><br></p>