products
Would you like to react to this message? Create an account in a few clicks or log in to continue.
products

products and price


You are not connected. Please login or register

What problems need attention when using the strapping machine

Go down  Message [Page 1 of 1]

Admin


Admin

<p>The <a href="https://www.ntjl.com/strapping-machine" rel="noopener noreferrer" target="_blank">strapping machine</a> is a common way in modern packaging. The simple and light packaging of the strapping machine will not bring additional burdens to handling and storage. Therefore, the strapping machine is indispensable for packaging in food, electronics, beverages, washing, cosmetics and other industries. device of. During the daily use of the strapping machine, the following problems are prone to occur, let's take a look at it together.</p><p><br></p><p>The strapping machine heats up slowly or cannot reach the standard packaging temperature: the above problems will cause the strapping machine's packaging effect to fail to meet expectations. The heating process depends on the heater, so the main power supply circuit of the heater should be checked first to check whether the contacts of the magnetic attraction switch are normal. If the magnetic switch is normal, check the meter again to see if the ohmic value of each phase is the same as that of the machine. Normally, it is a short circuit. If all phases are connected but the circuit or electric heating tube is still abnormal, the heater is damaged, just replace with a new heater.</p><p><br></p><p>The strapping machine cannot detect the product: the consequence of not detecting the product is that the product is damaged and the packaging cannot be performed normally. This situation occurs mainly because the gap in the middle of the combined package product affects the detection of the electric eye, so only the detection angle of the electric eye needs to be adjusted to an oblique angle.</p><p><br></p><p>The film material of the strapping machine is easy to shift and cannot be fed normally: the above situation can be solved by adjusting the position of the film roll and the tension balance bar. The adjustment is invalid, and then adjust the angle of the upper triangle.</p><p><br></p><p>The above has introduced the problems that are prone to using the strapping machine. I hope it can be helpful to everyone.</p><p><br></p><p><br></p>

https://weyes123.666forum.com

Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum