Home
<p>When cleaning a large number of SKF bearings, first use hot engine oil with a temperature of 90 ~ 100 ℃ to drench the package oil, at the same time dig out all the old oil with a seamless and non-chip tool, then drench it for a few minutes, then use kerosene Rinse off the engine oil and finally clean it with gasoline again. After cleaning, wear film gloves and place the SKF bearing on a clean cloth or paper on the table to dry. </p><p><br></p><p>Before the <a href="https://www.cytransmission.com/original-brand-skf-bearing-6005zz-from-japan" rel="noopener noreferrer" target="_blank">SKF bearing</a> device, you should use appropriate measurement tools to check the processing quality of the shaft and the seat hole and related parts, such as dimensional accuracy, shape accuracy and appearance roughness, etc. according to the technical request rules on the design drawings. The SKF bearing is encapsulated, and it is immersed in the above-mentioned gasoline and other liquids to rotate slowly by hand. </p><p><br></p><p>To ensure that the sealing oil on the surface of the holding frame, rolling elements and raceway is thoroughly cleaned, the gathering surface should be cleaned with a solution of clean gasoline, kerosene, toluene or xylene, and wiped dry with a clean rag, then coated with a thin A thin layer of smooth oil will make the operation of the device easier. Note that sealed SKF bearings cannot be cleaned by this method. The sealed interior should not be cleaned as it is. </p><p><br></p><p>There are bruises, burrs, rust or solid particles (such as abrasive debris, sand, and dirt) on the surface of the shaft and bearing housing gathering. Existence will not only make the SKF bearing device difficult and make the device position incorrect, but solid particles will play a grinding role if they fall into the SKF bearing. When the SKF bearing rotates, it will scratch or scratch the working appearance of the SKF bearing, so it must be carefully checked before the device. If the above defects are found, they should be corrected. For example, use an oil file to remove burrs, bumps, rust spots, and polish with a fine emery cloth, such as cleaning solid particles and dirt.</p>
products
