Polycarbonate rolling door installation method and precautions

<p><a href="https://www.zhtdoors.com/polycarbonate-rolling-door" rel="noopener noreferrer" target="_blank">Polycarbonate rolling door</a>&nbsp;are more common in villa balconies, banks, and subway stations, and have the advantages of transparency, anti-theft, rain resistance, dust and dust prevention. Now the polycarbonate rolling door&nbsp;has become the best alternative to the traditional roller shutter door. The noise can be greatly reduced after the door is closed, providing a quiet working environment. The transparency of the polycarbonate rolling door&nbsp;can provide the highest visibility, making the working environment more reliable.</p><p><br></p><p>The polycarbonate rolling door&nbsp;is so good, but how to decorate it? Today, China and Thailand will introduce the installation method of the polycarbonate rolling door.</p><p><br></p><p>Polycarbonate rolling door&nbsp;installation method:</p><p>1. First, see if the manual chain is down. When fixing the motor on the main board, when connecting the chain to the wheel and the motor base gear (must be tight), connect the remote control junction box to the motor, try to check if the handle is reversed If there is a black button on the side of the remote control receiving box upside down, just turn the other side to help.</p><p>2. Use a ruler to measure the outer edge of the main board and the auxiliary board to see if the size is correct. If the shaft is correctly placed on the side board, pay attention to first punch a horizontal line on the shaft, and then use 10 drills to punch 50 cm Straight, then use 14 screws to weld on the shaft, remember to weld perpendicular to the hole on the shaft, be sure to weld firmly, and then align the center of the curtain with the hole on the shaft and use 10 drill bits The punching hole must be vertical (can also be fastened with fast wire).</p><p>3. After wearing the roller shutter door curtains on both sides, seal them with heads and pull them with rivets (remember to start sealing one by one)</p><p>4. After sealing, use the rope to turn over the shaft to make a hole on the curtain and fasten the rope with one end, don't pull it at the other end with a person. Connect them together (to tighten the pads horizontally) and then lift the curtain up, it must be firm.</p><p>5. Open one end of the track into a mouth.</p><p>6. Level the roller shutter door curtain, position the upper and lower lines, the left pulley is the upper limit, and the right is the lower limit, (adjust according to the needs of the site).</p><p><br></p><p>Precautions for installation of crystal shutter door:</p><p>a) Standard voltage 220V</p><p>b) No one is allowed to stand under the crystal rolling door</p><p>c) There must be no obstacles when the crystal shutter door runs down</p><p>d) The crystal shutter door will automatically stop and open inside when descending (or press the stop button)</p><p>e) The crystal shutter door will automatically stop when ascending</p><p>f) Do not allow people and vehicles to pass through during operation</p><p>g) Minors need to use under guardianship</p><p><br></p>