How to install subway gates?

<p>After we have purchased a set of wing gate control gate products, if we want to realize the independent installation of wing gate control, we may spend a few minutes reading the following seven-step wing gate installation steps, I believe this is not only It is a reference process, and you will find out if there is any negligence during the installation process.</p><p><br></p><p>The first step is to choose the material: choose the communication cable, the eight-core network cable is the best choice; choose the embedded pipe, the 6-point galvanized pipe is the best (two and three directions when buying the adapter); choose the power cord, national standard The cable is the best.</p><p><br></p><p>The second step is to establish the installation plan of the <a href="https://www.keyable.com.cn/ksp1520-optical-swing-speed-gate-turnstile" rel="noopener noreferrer" target="_blank">wing gate</a> access control gate: the wiring path, the installation position of the chassis, and other places that need attention are considered.</p><p><br></p><p>The third step is to deal with the line: excavate the line ditch of the line in accordance with the installation plan of the wing gate gate forbidden gate in the second step.</p><p><br></p><p>The fourth step is to complete the line treatment: bury the pre-buried pipe according to the third step, and wait for the cement to dry before performing the next step.</p><p><br></p><p>Step 5: Make the communication line and power line according to the wiring requirements of the wing gate access control installation plan, and the underground wiring should be tight to prevent the wire from being corroded.</p><p><br></p><p>Step 6: Fix the position of the gate in accordance with the installation plan of the wing gate access control gate. Connect the wiring to connect the entire wing gate access control gate system as a whole. Remember to apply glass glue on the outside of the gate after completing the entire installation process.</p><p><br></p><p>The seventh step is the end: check whether there is a loophole in the entire line, check whether all the gates are fixed without any problems, and check whether the power can work normally after the check is completed</p>