products
Would you like to react to this message? Create an account in a few clicks or log in to continue.
products

products and price


You are not connected. Please login or register

What should be paid attention to when using mechanical seals?

Go down  Message [Page 1 of 1]

Admin


Admin

<p>&nbsp;In the process of using <a href="https://www.lepu<a href="https://www.lepuseal.com/" target="_blank">seal</a>.com/" target="_blank">mechanical</a> seals, we need to pay attention to many problems, which can reduce the occurrence of problems. The following editor will tell you about the problems of using<strong> mechanical seal</strong>s.</p><p><br></p><p>1.It is forbidden to bump or hit during the process of the equipment to prevent the <a href="https://www.lepuseal.com/" rel="noopener noreferrer" target="_blank">mechanical seal</a> from resisting damage and causing the seal to fail.</p><p><br></p><p>2.The radial runout of the imported mechanical seal of the equipment shaft should be ≤ 0.04 mm, and the axial movement amount should not be greater than 0.1 mm;</p><p><br></p><p>3.The sealed parts of the equipment should be kept clean when the equipment is used, the sealing parts should be cleaned, and the sealing end face should be intact to prevent impurities and dust from being brought into the sealed parts by the cartridge <a href="https://www.lepuseal.com/" rel="noopener noreferrer" target="_blank">mechanical seal</a>;</p><p><br></p><p>4.Push the moving ring by hand after the device, which can make the moving ring move on the shaft and have a certain elasticity;</p><p><br></p><p>5.When the equipment is in contact with the seal, it should be coated with a layer of clean mechanical oil in order to smooth the equipment;</p><p><br></p><p>6.After the device is used to move the shaft by hand, the shaft should have no light or heavy feeling;</p><p><br></p><p>7.When the static ring gland of the device is tightened, it is necessary to tighten the screws evenly to ensure that the end face of the static ring is perpendicular to the axis line;</p><p><br></p><p>8. It is necessary to fill the equipment with medium before operation to prevent dry interference and make the seal invalid.</p><p><br></p><p><br></p><p>Get more information, please contact: <a href="https://www.lepuseal.com/" rel="noopener noreferrer" target="_blank">https://www.lepuseal.com/</a></p>

https://weyes123.666forum.com

Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum