What is the hot tooth gum filling system

<p><a href="https://www.denjoy.cn/" rel="noopener noreferrer" target="_blank">Hot tooth gum filling system</a> is an instrument that softens the heated tooth gum into the root canal to replace the traditional cold side pressure filling. Because it can be fast, accurate, and dense three-dimensional root canal filling, it is widely praised by doctors, and it will definitely bring a impact on root canal filling.</p><p><br></p><p>Instructions</p><p>1. Select the heating pen tip, the taper of the heating pen tip is the same as that of the main tooth tip. The heating pen tip is placed at a locking point in the root canal, and the locking point is about 5 mm away from the physiological root tip hole. Adjust the heating nib rubber sheet to the highest reference point of the maxillofacial surface. The heating nib can be slightly pre-bent to adapt to the curved root canal.</p><p>2. Dry the root canal, cut off the tip of the main tooth gum tip with a working length of 0.5mm, and apply a thin layer of root canal sealant to the root canal wall</p><p>3. Use the tip of the heating pen to scald the gum tip of the root canal</p><p>4. Use a large vertical pressurizer to pressurize the root canal towards the root</p><p>5. Place the tip of the heating pen on the gum tip of the root canal, touch the heating switch, and pressurize the root at the same time. Press the tip of the heating pen to 3mm~4mm above the locking point, release the heating switch, stop heating for 10 seconds and remove it after heating for 1 second</p><p>6. Continue to apply pressure to the root, press the heating pen tip to 1mm from the locking point</p><p>7. Continue to pressurize continuously for 10 seconds to prevent shrinkage of the gum when it becomes hot and cold</p><p>8. While continuing to apply pressure to the root, touch the heating switch for 1 second, release the heating switch, and after a pause of 1 second, quickly pull the heating pen tip out of the root canal. (Note: Two-thirds of the gum in the root canal will be taken out of the root canal by the heated pen tip)</p><p>9. After pulling out the heating pen tip, use a vertical press to quickly compact the gum at the apex</p><p>10. Fill the root tip 1/3, then use a heat gun to fill the root canal with the last 2/3</p><p>11. Insert the dental glue injection needle into the root canal, and make the dental glue injection needle contact with the dental glue at 1/3 of the root apex.</p><p>12. Inject dental glue under pressure. Move slowly to the crown and maintain the reverse thrust to help prevent the formation of bubbles. Every time a certain amount of tooth gel is injected, it is immediately compacted with a suitable vertical pressurizer, and finally the tooth gel is injected and filled into the root canal port, and the tooth gel is injected into the root canal port. Compacted. .</p><p>Features</p><p>——A more efficient, safer, faster and more complete root canal filling system.</p><p>——Filling is fast and precise.</p><p>——Three-dimensional filling can make the root canal more closed.</p><p>——Flexible choice of filling method.</p><p>-Perfect vertex control and complete filling of the entire root canal (including filling of root canal branches).</p><p>——The two-in-one system makes filling easier and more convenient.</p><p>-Compressible tooth gel makes the filling compact.</p><p>——The digital display of temperature adjustment makes temperature adjustment more convenient.</p><p>——The compressed tooth gum tip is more compact.</p><p>——Friendly operation interface design.</p><p>——The machine is more compact and more ergonomic</p>