Home
<p>How to make the <a href="https://www.chz-lighting.com/street-lighting" rel="noopener noreferrer" target="_blank"><strong>night view street lighting</strong></a> engineering used in the LED lighting lamps and lanterns were satisfied to use the standard of service life and brightness, the LED lighting lamps and lanterns should keep long life and high brightness, the problem to be solved is: power supply, LED light source, cooling, security, four key technologies. </p><p><br></p><p>These key technologies directly decides the degree of quality and durability of rope! </p><p><br></p><p>CHZ Lighting gives you talk about the four key technology. </p><p><br></p><p>1, The first of required power supply is of high efficiency and high efficiency products, hot stability is low, it must be high. </p><p><br></p><p>Usually in power supply some useful isolation and the isolation of two solutions, isolation of large volume, low efficiency, in use, the installation will create many problems, as the isolated product market prospect is big, here we mainly discuss the isolation drive solutions. </p><p><br></p><p>2, LED light source adopts Taiwan ryukyu and cummings patent structure LED light source, its chips are placed in the feet, and heat over silver feet chips directly to the node of tropical, with traditional into products, and traditional patch products in terms of heat dissipation is different, the chip node won't produce cumulative temperature, thus ensuring the good usability of light source lamp beads, guarantee long life light source lamp beads, low light failure. </p><p><br></p><p>Traditional patch products, although can through the chip of gold thread connection is negative, but also let the heat energy produced is chip, silver, gold wire connected to the thermal and electrical conduction are all from the transmission of money, the accumulation of heat in the long run will directly affect the service life of LED fluorescent tube. </p><p><br></p><p>3, Heat to the introduction of the infrared radiation heat and applied to the fluorescent tube, is an important means of improving the service life of the bulb. </p><p><br></p><p>Considered in heat dissipation, we will LED light source lamp beads, cooling and power of heat to separate each other, so as to ensure the rationality of the heat dissipation. </p><p><br></p><p>There are three kinds of way of heat transfer, convection, conduction and radiation. </p><p><br></p><p>Convection and conduction in a closed environment, the implementation may be small, and the heat by radiation, and is the focus of the fluorescent tube to consider. </p><p><br></p><p>4, Safety, security, here basically said PC flame retardant plastic tubes, because the infrared heat radiation can penetrate the PC tube, then we design considerations LED lights, when using can more considering the safety, use of all plastic physical insulation way, even in the use of isolated power supply can absolutely guarantee the safety of use. </p><p><br></p><p>The development of <a href="https://www.chz-lighting.com/street-lighting" rel="noopener noreferrer" target="_blank"><strong>LED street lighting</strong></a> lamps and lanterns has been quite a long time, from the point of the effect of energy saving and its future application is quite broad, in addition to the energy conservation, the security and the use of long life is that we should be more attention. </p>
products
