Home
<p>When using the water <a href="https://www.onelynn.net/" target="_blank">softening water equipment</a>, the staff should also master the use methods and precautions of the water softening equipment. Avoid large and small failures in the later operation of the equipment, and mastering the use method will also create more economic benefits for users.</p><p><br></p><p> When using the softening water equipment, the staff should also master the use methods and precautions of the water softening equipment. Avoid large and small failures in the later operation of the equipment, and mastering the use method will also create more economic benefits for users. The editor of this article will talk about some precautions that must be followed when using water softening equipment.</p><p> </p><p> <a href="https://www.onelynn.net/" rel="noopener noreferrer" target="_blank"><strong> Automatic water softening device</strong> </a>is a kind of equipment with the function of softening the hardness of water. Since the hardness of water is mainly formed by calcium and magnesium, automatic water softening equipment manufacturers use ion exchange resin to remove calcium and magnesium and other scale ions in the water. When the raw water containing hardness ions passes through the resin layer in the exchanger, the calcium and magnesium ions in the water are replaced with the sodium ions adsorbed by the resin. The resin adsorbs the calcium and magnesium ions and the sodium ions enter the water.</p><p> </p><p> Regarding the filling of quartz sand and resin, in order to ensure the level of distribution, try to place 150~200mm of good quality quartz sand (not synthesized to produce silicon oxides or salts) at the bottom of the AC column. Before filling the resin, check the center lift pipe Is the length suitable? First snap the water distributor into the central socket at the bottom of the automatic control head (control valve), then align the lower end of the center tube with the socket at the bottom of the AC column, and insert the upper end into the lower nozzle of the upper water distributor.</p><p> </p><p> Then carefully screw into the upper screw port of the AC column in a clockwise direction to confirm that the entire control valve screw can be smoothly screwed into the upper screw port of the AC column to confirm that the length of the center tube meets the requirements, and the center lift tube can be tightly connected The valve head does not stick to concentricity. After the above-mentioned trial-installed machine head is finished, rotate the machine head counterclockwise and take it off again, and once again keep the center tube in the center, align the end point of the lower water distributor under the bottom of the center lift tube with the bottom end of the original fixed center lift tube to the bottom slot, and use a soft cloth Or a plastic belt seals the upper entrance of the center lift pipe, and the beginning is evenly filled with quartz sand or resin.</p><p> </p><p> When filling the resin, pay attention to the balanced filling around the lift pipe of the human center. In order to ensure that the calculated quantity is loaded into the column as much as possible, with the installation process, clean water should be injected into the AC column from time to time to exhaust the air in the resin pores. . It is the best way to maintain this kind of water-sealed state to fill with resin. Dry resin is difficult to guarantee the amount of filling that should be used. After the resin is filled, screw the control valve clockwise into the threaded port on the upper end of the AC column again.</p>
products
